pfc1600

Output Voltage:	350 Vdc at 85-230 Vac increasing linearly to 380 Vdc from 230-264 Vac.
Output Power:	1600 W max. at 170-264 Vac1200 W max. at 95-264 Vac1000 W max. at 85-264 Vac
Input Voltage/Current:	85-264 Vac, 47-63 Hz, 15 A max., single phase
Auxiliary Output:	+12 Vdc at 50 mA max., can tolerate short circuit for up to 5 sec.
Power Factor:	0.99 typical
Inrush Current:	40 A max.
Efficiency:	94% typical
Holdup Time:	20 msec min. from input power failure until AC OKsignal goes low, full load and 85-264 Vac
AC Fail Warning:	5 msec continued operation after AC OK signal drops
Output Ripple:	18 V pk-pk max.
Turn-on Time:	800 msec max. until Load Enable signal goes high
Line Regulation:	2% max. output variation over full input range
Load Regulation:	2% max. output variation from no load to full load
Overvoltage Protection:	Output limited to 400 Vdc
Overload Protection:	Input current limited to 15 A rms
Thermal Protection:	Internal shutdown cycles automatically
Input Fuse:	Internal one-pole 16A NTD fuse
Output Short Protection:	External fuses required at dc-dc converters
Leakage Current:	1.0 mA max. at 240 Vac
Hipot:	2200 Vdc

(All signals referenced to RETURN)
On/Standby Switch:	Connect to return with front panel switch to turn on
Return:	Signal return (can be connected to system ground)
AC OK:	TTL high indicates input and output voltages OK
+12 Vdc Aux:	+12 Vdc at 50 mA max. (overload will shut off PFC)
Load Enable:	+12 Vdc active high for controlling dc-dc converters (Load enable signal must be used to activate load for proper AC inrush limit operation)
Operating Temperature:	-20°C to 70°C. Full power to 50°C, derate to 50% at 70°C
Storage Temperature:	-40°C to 85°C
Size/Weight:	2.6"H x 4.4"W x 7.7"L, 3.0 lbs.
Shock and Vibration:	Mil-Hdbk 810E
Humidity:	95% non-condensing
Mating Connector:	5 pin control connector AMP part no. 102241-3

(All signals referenced to RETURN)
On/Standby Switch:	Connect to return with front panel switch to turn on
Return:	Signal return (can be connected to system ground)
AC OK:	TTL high indicates input and output voltages OK
+12 Vdc Aux:	+12 Vdc at 50 mA max. (overload will shut off PFC)
Load Enable:	+12 Vdc active high for controlling dc-dc converters (Load enable signal must be used to activate load for proper AC inrush limit operation)
Operating Temperature:	-20°C to 70°C. Full power to 50°C, derate to 50% at 70°C
Storage Temperature:	-40°C to 85°C
Size/Weight:	2.6"H x 4.4"W x 7.7"L, 3.0 lbs.
Shock and Vibration:	Mil-Hdbk 810E
Humidity:	95% non-condensing
Mating Connector:	5 pin control connector AMP part no. 102241-3

PFC1600

V for standard variable output voltage, F for fixed 380V