• Full size SBC with PCI/ISA Golden finger
• Intel® Socket 370 Celeron™/Pentium® III with 66/100/133MHz FSB
• PCI V2.1 complied
• PICMG 1.0 (Rev.2.0) complied

• Intel® Brand New Socket 370 FC-PGA Celeron™ / Pentium® III CPU with 128/256K cache on die, running at 66/100/133MHz FSB up to 1GHz
• Support streaming SIMD instruction

• Support SDRAM up to 512MB (Max.)
• 168 pin DIMM socket x 2
• Support 100/133MHz SDRAM interface

• Award System BIOS
• Plug & Play support
• Advanced Power Management support
• Advanced Configuration & Power Interface support
• Jumperless for CPU FSB
• 2M bits flash ROM, upgradeable to 4M bits

• Intel® 815E chipsets

  82815 x 1 Graphics and Memory Controller Hub (GMCH)

  82801 x 1 I/O Controller Hub (ICH2)

  82802 x 1 Firmware Hub (FWH)

• ITE 8888F x 1 PCI to ISA Bridge

• Intel® 82815 (GMCH) chipset integrated with Graphics controller
• Hardware motion compensation assist for software MPEG/DVD decode
• 15 pin CRT connector x 1
• Optional TFT LCD/DSTN LCD/CRT control module through proprietary connector

• ATI Rage Mobility M4 3D VGA accelerator. 4X AGP
• Fully PC 98 and PC 99 Compliant.
• Integrated 8MB of SDR Memory, upgradeable to 16MB
• 15 pin CRT connector x 1, DVI interface connector x 1

• Dual channel Ethernet support
• Intel® 82801 (ICH2) chipset integrated LAN controller
• Intel® 82559 Single Ethernet controller
• Alert-on-LAN by Intel® 82801 (ICH2)
• 10 Base T/100 Base TX support, full duplex
• Complied with PCI V2.1, IEEE802.3, IEEE 802.3U
• Drivers support: DOS/Windows®, Windows® 95/98/2000, Windows® NT4.0, Netware, SCO Open Server 5.0, Linux.
• RJ45 connector x 2

• Reserved 32bit PCI interface for EBKSCSI / EBKSCSI2 / EBKSCSI 160D module

• ITE 8712 Enhanced Super I/O on board
• SIO x2, with 2x16C550 UARTs, 10 pin header x2, Optional RS422/485 x1
• PIO x1, bi-directional, EPP/ECP support, 26 pin connector x1
• Floppy Disk controller: 5.25" 360KB/1.2MB, 3.5" 720KB/1.2MB/1.44MB/2.88MB support, 34 pin connector x1
• On chip enhanced IDE x 2, PIO up to mode 4, DMA master up to mode 2, Ultra DMA/66/100 support, 40 pin connector x 2, total 4 E.IDE devices support
• On chip Keyboard, mouse controller, 5 pin connector x 1(for other keyboard); 6 pin mini DIN connector x1, for PS/2 keyboard/mouse
• On board USB port x4 (6 pin header x2)
• On Board buzzer x1
• On board 2 pin header for I²C
• On board 5 pin header for IrDA
• On Board 2 pin header for reset SW, 4 pin for speaker, 5 pin for keylock, 2 pin power SW

• Soft Power off
• Wake On LAN
• Wake On Keyboard
• Wake On Ring
• RTC alarm wake up

• On board reserved socket for DOC of M-system : 2MB~288MB, etc
• Power header beside IDE connector to support DOM

• Derived from Super IO ITE 8712 to support system monitor.
• 8 voltage (For +3.3V, +5V, -5V , 5V STBY, +12V, -12V, and Vcore x2)
• One Fan speed (For CPU)
• Two temperature
• Drivers support: Windows® 95/98, Windows® NT4.0/2000, Linux

• PS/2 connector x1 (for Keyboard/Mouse)
• RJ45 connector x2 (for LAN)
• 15 pin D-type connector x1 (for VGA)
• Optional bracket for 2xCOM ; PIO + COM ; USB x2 + DVI

• Maximize ISA signals to support ISA cards up to 20

• 1, 2, 4... 64 seconds time-out intervals

• 340mm(L) x 122mm(W)

	Typical	Maximum
+5V	10A	15A
-5V	0.5A	1A
+12V	0.5A	1A
-12V	0.5A	1A
+5Vsb	1.2A	1.5A

 

• Operating temperatures: 0°C to 60°C
• Storage temperatures: -20°C to 80°C
• Relative humidity: 10% to 90% (Non-condensing)

• CE approval
• FCC Class A