• 102.6mm(W) x 25mm(H) x 203mm(D)

• Micro Controller
  Atmel AT 89C51 micro controller (Intel® 8051 series compatible)
  • 4KB flash memory on chip
  • 128bytes RAM on chip

   

• I²C Interface

   

• On board 32KB SRAM (reserved) for programming

   

• The detector
  Winbond 83782 D x 3; each with
  • Thermal input x 3 (Max input x 9), range from -30°C to 90°C,
  • Voltage input x 6: +5V, +12V, +3.3V, +5V standby, -12V, -5V
  • Fan speed input x 3 (Max input x 9)
  • I²C Interface to AT89C5

   

• I/O's: RS 232 x 1, I²C x 1, Buzzer x 1

   

• ID Control
  • 3 digit switch for up to 1000 ID's
  • Multiple segments possible

   

• Fan on / off control by software

   

• I/O Connectors
  • Power terminal block x 1 (9 pin)
  • Additional 4 pin power connector x 1
  • 2 pin I²C connector x 1
  • 10 pin RS-232 connector x 1
  • Fan power connector x 9 (3 pin each)
  • Temperature connector x 9 (2 pin each)
  • LCD/KeyPad connector x 1 (I²C x 2 pin, power x 2 pin)
  • Additional pin x 2 set for HDD LED
  • Integrated LED connector x 1
  • LED module with temperature x 4, Fan x 1, Power x 6, HDD x 1

   

• Power Requirements
  • +5V: 3A (Max)
  • +12V: 9A (Max) for fan

   

• Dimension : 155x100mm

   

• Environment
  • Operating temperatures: 0°C to 60°C
  • Storage temperatures: -20°C to 80°C
  • Relative humidity: 10% to 90% (Non-condensing)

   

• Certificate: FCC class A, CE.

   

• MTBF: Over 100 thousand hours

   

• NXC-LS8 Multi-node sequential display (Console to 8 clients)
• NXC-LS16: Multi-node sequential display (Console to 16 clients)
• NXC-LS32: Multi-node sequential display (Console to 32 clients)
• NXC-LS64: Multi-node sequential display (Console to 64 clients)

• Target can deliver an urgent message to console
  When monitored target encounters trouble, such as fan or temperature error etc, the target will notify the console by sending an urgent error message to the console.

   

• Remote-Shutdown the monitored target
  When the temperature of monitored target has exceeded the preset level, the console will shutdown the machine automatically.

   

• Auto Dialing-out error message
  When console detects an error in nodes that were all connected together by hub, the console can dial out through the external modem to the remote machine to notify the supervisor.

   

• Can Dynamic see the information of each node
  The console can see all the information of a node, but only one at a time. It allows the user to switch from this node to another node.

 

NXC 30 Temperature x 3, Fan x 3, voltage x 6 (LAN) NXC 60 Temperature x 6, Fan x 6, voltage x 6 (LAN) NXC 90 Temperature x 9, Fan x 9, voltage x 6 (LAN)

Top